Bituprime Coating - P01-S is a bitumen primer that is a suitable solution for single-coat applications and it is usable for all types of substrates. It contains high-quality petroleum bitumen and a special solvent that the softening temperature is not lower than 70°C.
Product technical data
PROPERTIES | PERFORMANCE |
|---|---|
Appearance | Black, low-viscosity liquid |
Mass fraction of non-volatile substances, % | 45 - 55 |
Drying time at 20°C, hours | 12 |
Softening temperature, °С | 70 |
Relative viscosity, s | 15 - 40 |
Solvent resistance | Poor |
Bucket volume, l | 10, 20 |
Application areas:
To achieve strong adhesion of materials to porous, rough and dusty surfaces, possible to use Bituprime® Coating. It’s suitable to prime concrete roofs and floors, cementitious screeds/renders, brickwork, bitumen felt, weathered bitumen, mastic asphalt, weathered, corrugated iron and steel.
Limitations:
Not suitable for potable drinking water tanks.
Bitumen compounds tend to bleed through and discolor paints are subsequently applied over it. Apply a primer recommended by the paint manufacturer before painting
Consumption:
Bituprime® Coating – P01 consumption per m2 will be 0.25–0.35 l/m2 (1 l per 3.33 m2).
Method of application:
Bituprime® Coating – P01 should be applied to the prepared surface clear of any debris or sharp projections.
Ensure surfaces are clean, dry and free of loose materials, dust, grease, rust and other contaminants. Defects such as cracks should be repaired before primer application. For metal surfaces (old) should remove any flaking material or rust with a wire brush. For previously coated surfaces should completely remove any old paint first then apply the new coating layer.
The bitumen primer should be applied in a continuous coat using a roll or brush penetrating the surface and providing a smooth and well-adhered base for subsequent waterproofing layers.
Advantages:
- Improves the bond of bituminous materials
- Binder for dust particles
- Surface dressing to masonry and metal surfaces
- Water-resistant.
- Corrosion and chemical resistant.
- Penetrates and seals porous surfaces.
- Fast-drying.
- Cost-effective, no heating, thinning or mixing.
- Compatible with various substrates and structures
- Can be used at temperatures below 0°C
Safety instructions
Bituprime® Coating – P01 contains a flammable, toxic solvent. Always work in a ventilated area. Do not breathe in vapors. Avoid exposing the product to any ignition sources. Do not smoke when working with Bituprime® Coating. It is advisable to wear gloves and safety glasses to avoid direct contact with skin or eyes. If the product comes into contact with skin or eyes, rinse thoroughly and immediately with water. Seek medical attention if irritation or discomfort persists. Protect from sunlight and do not expose to temperatures exceeding 40°C. Keep out of reach of children! Refer to our Safety Data Sheet for further toxicological information and comprehensive handling instructions
Storage:
Store in a dry place protected against sunlight at a temperature between -20°C and +30°C. Shelf life is 18 months.
Availability
Bituprime® Coating – P01 is available in:
Bulk
IBC Tank, Flexi Tank
Reconditioned steel drums 220 lit., Net Weight: 200 ± 3 Kg
New steel drums 220 lit., Net Weight: 200 ± 3 Kg
20 Lit pails